Which of the following is/are restriction(s) in classless addressing ?
All of the above
In classless (CIDR) addressing a block must contain a power-of-two number of addresses, and its first address must be evenly divisible by that number.
Because there are no classes, the block is defined only when the mask or prefix length is written with the address, as in a.b.c.d/n.
All three statements are therefore restrictions of classless addressing.
Hence, All of the above.
In a classful addressing, first four bits in Class D IP address is
In a classful addressing, the IP addresses with 0 (zero) as network number :
Which of the following fields in IPv 4 datagram is not related to fragmentation ?
What is the size of the ‘total length’ field in IPv 4 datagram ?
A network on the Internet has a subnet mask of 255.255.240.0. What is the maximum number of hosts it can handle ?
Which of the following is used in the options field of IPv4 ?
Match List - I with List - II.
| List - I (IP Address) | List - II (Class) |
|---|---|
| (A) 10.20.30.40 | (I) Class E |
| (B) 210.20.30.3 | (II) Class B |
| (C) 180.30.100.10 | (III) Class A |
| (D) 252.5.15.11 | (IV) Class C |
Choose the correct answer from the options given below :
Host A (on TCP/IPv4 Networks) send an IP Datagram D to host B (also on TCP/IPv4 network). Assume that no error occured during transmission of D, when D reaches B. Which of following header field may differ from that of original datagram D ?
(A) TTL
(B) Checksum
(C) Fragment offset
(D) Source IP
(E) Destination IP
Choose the correct answer from the options given below :
(A) In IPv4 addressing, a block of address can be define as x.y.z.t/n in which x.y.z.t define one of the address and /n define the mask
(B) The first address in the block can be found by setting the rightmost 32-n bits to 0s
(C) Address of class C is used for multicast communication
(D) There are five classes in IPv4 address
(E) Supernetting combine several networks into one large network
Choose the correct answer from the options given below :
Consider two hosts P and Q are connected through a router R. The maximum transfer unit (MTU) value of the link between P and R is 1500 bytes and between R and Q is 820 bytes. A TCP segment of size of 1400 bytes is transferred from P to Q through R with IP identification value of 0x12334. Assume that IP header size is 20 bytes. Further the packet is allowed to be fragmented that is Don’t Fragment (DF) flag in the IP Header is not set by P.
Which of the following statement is/are not true?
A. Two fragments are created at R and IP datagram size carrying the second fragment is 620 bytes
B. If the second fragment is lost then R resend the fragment with IP Identification value of 0x1234
C. If the second fragment lost then P required to resend the entire TCP segment
D. TCP destination port can be determined by analyzing the second fragment only
Choose the correct answer from the options given below:
Suppose a message of size 15000 bytes is transmitted from a source to a destination using IPv4 protocol via two routers as shown in the figure. Each router has a defined maximum transmission unit (MTU) as shown in the figure, including IP header. The number of fragments that will be delivered to the destination is ________ . (Answer in integer)

Which class of IPv4 addresses supports the largest number of host addresses in a computer network?