Component Dimension Measured Size Explained
The term used for the size of a component's dimension that has been physically measured is the Actual size.
Understanding Dimension Terms
In engineering and manufacturing, dimensions have specific terms:
- Actual size: This is the size of a part as it has been measured from the finished component. It reflects the real-world measurement.
- Basic size: This is the theoretical size from which the limits of size (maximum and minimum) are derived by applying tolerances. It's the starting point for design calculations.
- Normal size: This term is not typically used in the context of specific dimension measurements in engineering standards.
- Allowed size: This refers to the range within which the actual size must fall. It is defined by the maximum and minimum permissible sizes, determined by the basic size and its tolerances.
Therefore, when a dimension is measured on a component, that measurement represents its Actual size.
Similar Questions
The difference between the maximum limit of size and minimum limit of size in assembling a product is known as:
The number of fundamental tolerance in the Indian Standard System are:
In an assembly, Hole size is smaller than shaft size then this type of fit is known as ______
When two mating parts are sometimes, an interference fit and sometimes a clearance fit is known as _____
The measured size of the dimension of a component is called ______ size.
The tolerance limit is 50.3 ± 0.05 mm.
What is this shown?
When tolerance is given on both sides of the basic dimension, it is called:
- When tolerance is given on one side of the basic dimension, it is called:
- Which type of fit is used when a small amount of clearance or interference is permissible?
- Two extreme permissible sizes of a part, between which actual size should lie is called _____
Important Questions from Limits and Fits
Which one of the following dimensions shows the largest tolerance?
In mass production, parts made to definite limit of error is called as ______
In a hole basis system, the lower deviation for the hole ‘H’ is
Name the fit, in which the shaft is cooled below the room temperature until it fits into the hole, then assembly is allowed to attain room temperature.
The type of fit in which the female part is fitted when male part is in hot condition is called _____
