Which RAID level is appropriate for storing the log file of a ticket booking system where a huge database update is required?
Level 1
RAID levels trade capacity, write performance and reliability. A transaction log of a booking system is written constantly (every update appends log records) and must survive a disk failure, because recovery depends on it.
RAID level 1 (mirroring) writes each block to two disks. It gives full redundancy and good write performance, since there is no parity to read and recompute on each small write. Standard database texts therefore recommend RAID 1 for log files and other data with a high update rate.
Level 0 (striping without redundancy) is fast but loses the log if any disk fails. Level 2 uses bit-level striping with Hamming-code disks and is practically unused. Level 3 uses a single parity disk with bit-interleaved striping, so every write involves the parity disk, making it slow for frequent small log writes.
Level 1 option is correct.
Consider a disk with 16384 bytes per track having a rotation time of 16 msec and average seek time of 40 msec. What is the time in msec to read a block of 1024 bytes from this disk ?
Match the LIST-I with LIST-II
| LIST-I | LIST-II |
|---|---|
| A. RAID level 1 | I. bit-interleaved parity organization |
| B. RAID level 2 | II. disk mirroring |
| C. RAID level 3 | III. block-interleaved parity organization |
| D. RAID level 4 | IV. ECC organization |
Choose the correct answer from the options given below:
If the disk platters rotate at 5400 rpm (revolutions per minute), then approximately what is the maximum rotational delay ?
For the disk described in the passage, assume the platters rotate at 5400 rpm and one complete track is transferred per revolution. Taking 1 KByte = 1024 bytes, what is the data transfer rate?
Consider a disk pack with 32 surfaces, 64 tracks and 512 sectors per pack. 256 bytes of data are stored in a bit serial manner in a sector. The number of bits required to specify a particular sector in the disk is
Which of the following can be said about primary storage in comparison with secondary storage?