The minimum frame length for 10 Mbps Ethernet is _______ bytes and maximum is _______ bytes.
64 & 1518
Standard (10 Mbps) Ethernet fixes the frame size so that collisions can be detected reliably while keeping buffers bounded.
The minimum frame is 64 bytes (46 bytes of data plus 18 bytes of header and CRC), long enough for the sender to still be transmitting when a collision returns.
The maximum frame is 1518 bytes (1500 bytes of payload plus 18 bytes of header and CRC).
Hence, 64 & 1518.
The network using CSMA/CD has a bandwidth of 20 mbps. If the maximum propagation time is 25μ sec (microsecond), what is the minimum size of the frame?
Consider a CSMA/CD network that transmits data at the rate of 100 Mbps over a 1 Kilometre cable with no repeater. If the minimum frame size required for this network is 1250 bytes, what is the signal speed (km/sec) in the cable.
The number of bits used for addressing in Gigabit Ethernet is _______.
Assume the host uses a correctly assigned, universally administered individual Ethernet address and that addresses are not duplicated or spoofed. The host is connected to a department network, which is part of a university network, which in turn is part of the Internet. The largest listed network within which this Ethernet address is unique is:
A network with bandwidth of 10 Mbps can pass only an average of 12,000 frames per minute with each frame carrying an average of 10,000 bits. What is the throughput of this network?
Which of the following communication modes supports two-way traffic, but in only one direction at a time?