Match the following : Codes :List – I List – II a. n · p i. 26 mV / I b. p-n diode ii. \(\dfrac{2}{|V_{P}|}\sqrt{I_{DS}\cdot I_{DSS}}\) c. JFET iii. ID = K(VGS – VGST)2 d. enhancement MOSFET iv. mass action law
a-iv, b-i, c-ii, d-iii
Two of the four pairings are unmistakable, and they fix the answer: a-iv, b-i, c-ii, d-iii — option 3.
| Item | Match | Why |
|---|---|---|
| a. n · p | iv. Mass action law | The product of the carrier concentrations |
| b. p-n diode | i. 26 mV / I | Dynamic resistance at room temperature |
| c. JFET | ii. Transconductance formula | Contains the pinch-off voltage and IDSS |
| d. Enhancement MOSFET | iii. Square law with VGST | Threshold appears explicitly |
a — the mass action law. In thermal equilibrium the product of electron and hole concentrations is a constant of the material, independent of doping:
\(np=n_{i}^{2}\)
Doping one type up drives the other down in exact proportion — add donors and the electron population rises while the hole population falls, because the increased electron density raises the recombination rate until balance is restored.
b — the diode's dynamic resistance. Differentiating the diode equation,
\(I=I_{S}\left(e^{V/\eta V_{T}}-1\right)\quad\Rightarrow\quad r_{d}=\dfrac{dV}{dI}=\dfrac{V_{T}}{I}=\dfrac{26\ \text{mV}}{I}\)
since the thermal voltage \(kT/q\) is 26 mV at 300 K. The small-signal resistance depends only on the operating current, which is why a diode at 1 mA presents 26 Ω and at 10 mA only 2.6 Ω — the basis of every diode-based variable attenuator.
c — the JFET transconductance. Differentiating Shockley's square law \(I_{D}=I_{DSS}\left(1-V_{GS}/V_{P}\right)^{2}\) gives
\(g_{m}=\dfrac{2}{|V_{P}|}\sqrt{I_{D}I_{DSS}}\)
The presence of \(V_{P}\) (pinch-off) and \(I_{DSS}\) (drain current at zero gate bias) marks this as JFET territory: both are quantities that only a depletion-mode device possesses.
d — the enhancement MOSFET. Its drain current is
\(I_{D}=K\left(V_{GS}-V_{GST}\right)^{2}\)
and the giveaway is \(V_{GST}\), the gate-source threshold. An enhancement device conducts nothing until the gate exceeds it, whereas a JFET is described by a pinch-off voltage at which conduction stops. Both laws are square, but they are anchored at opposite ends.
Hence, the correct code is a-iv, b-i, c-ii, d-iii.
| List – I (Devices) | List – II (Characteristics) |
| a. BJT | i. Voltage controlled negative resistance |
| b. MOSFET | ii. High current gain |
| c. Tunnel diode | iii. Voltage regulation |
| d. Zener diode | iv. High input impedance |
Codes :
Which of the following is NOT a state function or state variable in a thermodynamic system?