Match the following : Codes :(a) Line coding (i) A technique to change analog signal to digital data. (b) Block coding (ii) Provides synchronization without increasing number of bits. (c) Scrambling (iii) Process of converting digital data to digital signal. (d) Pulse code modulation (iv) Provides redundancy to ensure synchronization and inherits error detection.
(a)-(iii), (b)-(iv), (c)-(ii), (d)-(i)
These four techniques are the steps of digital transmission: turning data or analog signals into a digital signal and making that signal self-synchronising.
(a) Line coding maps a sequence of bits to a digital signal (NRZ, Manchester, AMI and so on); it is the process of converting digital data to a digital signal, so (a) matches (iii).
(b) Block coding replaces each m-bit group with an n-bit code word (for example 4B/5B), adding redundancy that guarantees enough transitions for synchronization and allows some error detection, so (b) matches (iv).
(c) Scrambling (B8ZS, HDB3) substitutes long runs of zeros with special patterns, giving synchronization without increasing the number of bits, so (c) matches (ii).
(d) Pulse code modulation samples, quantizes and encodes an analog signal, changing it into digital data, so (d) matches (i).
The other codes swap line coding with block coding or move PCM away from analog-to-digital conversion.
(a)-(iii), (b)-(iv), (c)-(ii), (d)-(i) option is correct.
What is the propagation time if the distance between the two points is 48,000 ? Assume the propagation speed to be \(2.4 \times 10^8\) metre/second in cable.
How many characters per second (7 bits + 1 parity) can be transmitted over a 3200 bps line if the transfer is asynchronous ? (Assuming 1 start bit and 1 stop bit)
For n devices in a network, ________ number of duplex-mode links are required for a mesh topology.
An analog signal has a bit rate of 6000 bps and a baud rate of 2000 baud. How many data elements are carried by each signal element ?
The period of a signal is 10 ms. What is its frequency in Hertz ?
A device is sending out data at the rate of 2000 bps. How long does it take to send a file of 1,00,000 characters ?
A network with bandwidth of 10 Mbps can pass only an average of 15,000 frames per minute with each frame carrying an average of 8,000 bits. What is the throughput of this network ?
In a typical mobile phone system with hexagonal cells, it is forbidden to reuse a frequency band in adjacent cells. If 840 frequencies are available, how many can be used in a given cell ?
Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is __________.
Suppose a digitized voice channel is made by digitizing 8 kHz bandwidth analog voice signal. It is required to sample the signal at twice the highest frequency (two samples per hertz). What is the bit rate required, if it is assumed that each sample requires 8 bits ?
Consider the following statements regarding modems used in computer network:
S1: Modems are required when communication medium carries analog signals
S2: Modulation converts digital data into analog form
S3: Demodulation converts analog data into digital form
S4: Modems assign MAC addresses to computers.
Which statements are TRUE?
Consider the following statements about RS-232 ports and connectors.
S1: DB9 connector is associated with RS-232
S2: RS-232 uses RJ45 connector for standard serial communication
S3: RS-232 communication is point-to-point.
Which statements are TRUE?
Which of the following statement(s) is/are correct?
I. Metropolitan area network is a collection of Local area network.
II. Metropolitan area network support both data and voices transmission.
Which of the following statements is TRUE about data transmission modes?
What is the propagation time if the distance between the two points is 48,000 ? Assume the propagation speed to be \(2.4 \times 10^8\) metre/second in cable.