All Exams Test series for 1 year @ ₹349 only
Question

An analog signal has a bit rate of 6000 bps and a baud rate of 2000 baud. How many data elements are carried by each signal element ?

This question was previously asked in
UGC NET 2014 Paper 1 Question Paper (28-Dec-2014)
The correct answer is

3 bits/baud

The bit rate N (bits per second) and the baud rate S (signal elements per second) are related by \(N = S \times r\), where r is the number of data elements (bits) carried by each signal element.

So \(r = \frac{N}{S} = \frac{6000}{2000} = 3\) bits per signal element.

Thus each signal element carries 3 bits, i.e. 3 bits/baud.

Hence, the answer is 3 bits/baud.

Was this answer helpful?

Similar Questions

  1. What is the propagation time if the distance between the two points is 48,000 ? Assume the propagation speed to be \(2.4 \times 10^8\) metre/second in cable.

  2. How many characters per second (7 bits + 1 parity) can be transmitted over a 3200 bps line if the transfer is asynchronous ? (Assuming 1 start bit and 1 stop bit)

  3. For n devices in a network, ________ number of duplex-mode links are required for a mesh topology.

  4. The period of a signal is 10 ms. What is its frequency in Hertz ?

  5. A device is sending out data at the rate of 2000 bps. How long does it take to send a file of 1,00,000 characters ?

  6. A network with bandwidth of 10 Mbps can pass only an average of 15,000 frames per minute with each frame carrying an average of 8,000 bits. What is the throughput of this network ?

  7. In a typical mobile phone system with hexagonal cells, it is forbidden to reuse a frequency band in adjacent cells. If 840 frequencies are available, how many can be used in a given cell ?

  8. Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is __________.

  9. Suppose a digitized voice channel is made by digitizing 8 kHz bandwidth analog voice signal. It is required to sample the signal at twice the highest frequency (two samples per hertz). What is the bit rate required, if it is assumed that each sample requires 8 bits ?

  10. Which transmission technique guarantees that data packets will be received by the receiver in the same order in which they were sent by the sender ?


Important Questions from Physical Layer

  1. Consider the following statements regarding modems used in computer network: 

    S1: Modems are required when communication medium carries analog signals 

    S2: Modulation converts digital data into analog form 

    S3: Demodulation converts analog data into digital form 

    S4: Modems assign MAC addresses to computers. 

    Which statements are TRUE?

  2. Consider the following statements about RS-232 ports and connectors. 

    S1: DB9 connector is associated with RS-232 

    S2: RS-232 uses RJ45 connector for standard serial communication 

    S3: RS-232 communication is point-to-point. 

    Which statements are TRUE?

  3. Which of the following statement(s) is/are correct?

    I. Metropolitan area network is a collection of Local area network.

    II. Metropolitan area network support both data and voices transmission.

  4. Which of the following statements is TRUE about data transmission modes?

  5. What is the propagation time if the distance between the two points is 48,000 ? Assume the propagation speed to be \(2.4 \times 10^8\) metre/second in cable.

Need Expert Advice?
Upcoming Exams
CTET
December 12, 2026
CBSE UGC NET
December 14, 2026
CSIR UGC NET
December 19, 2026
Test Series
UGC NET img
Teaching
UGC NET (Paper 2) 2026 Mock Test Series
796 Tests 2 Tests Free
120 Attempts
4.4(42)
English
More Questions from UGC NET

Start Your Preparation with Prepp Mobile App

Download the app from Google Play & App Store
Download the app from Google Play & App Store
Prepp Mobile App