For drilling a hole on a lathe, the drilling tool is placed in the ______.
tailstock
On a centre lathe the workpiece is held in the headstock and rotated, while cutting tools are brought to it from different fixtures depending on the operation. Understanding which fixture holds which tool is key here.
Why the tailstock is correct for drilling:
- The drill is mounted in the tailstock — either directly via its Morse-taper shank in the tailstock quill, or through a drill chuck fitted into the quill.
- The tailstock sits on the far end of the bed, aligned with the spindle axis, so the drill enters the rotating workpiece exactly on its centreline, producing a concentric (axial) hole.
- Feed is applied by turning the tailstock handwheel, which advances the quill and pushes the non-rotating drill into the spinning work.
Why the other options are wrong:
- The tool post holds turning, facing and boring tools mounted on the carriage; it is not used to feed a drill axially into the end of the work.
- The chuck (in the headstock) grips and rotates the workpiece, not the drill.
- The carriage carries the cross-slide and tool post for longitudinal/cross feed of turning tools, but the drill itself is not held there.
Similar Questions
During the 'Shaping' operation conducted on a workpiece of aluminum material, the type of coolant used is:
Why is a steady rest sometimes used in cylindrical grinding?
The type of surface produced by a taper turning operation performed on a lathe machine is:
Which component in a cylindrical grinding machine provides longitudinal movement to the workpiece?
Important Questions from Machining Processes and Machine Tools
For which material, the cutting speed will be maximum for machining?
Which of the following wear mechanisms is primarily responsible for the formation of crater wear on the rake face of a cutting tool?
The angle produced between the face of the tool and plane parallel to the base of the cutting tool is known as _______.
- In chemical machining, the etch factor is expressed as:
Which of the following relationship between shear angle ϕ, friction angle β and cutting rake angle α is known as Lee and Shaffer analysis
