Rivet value is defined as -
minimum of shearing and bearing strength of rivet
When designing structural joints using rivets, it's crucial to understand the strength of the joint. The strength of a single rivet is limited by its ability to resist different types of failure. The two primary modes of failure considered for a rivet itself are shearing and bearing.
The shearing strength refers to the rivet's resistance to being cut or sheared across its cross-section due to the forces applied by the connected plates pulling in opposite directions. The force tends to slice through the rivet body.
The bearing strength refers to the ability of the rivet or the plate material to resist crushing at the contact surface where the rivet presses against the plate hole. High forces can cause the rivet to crush the hole or the plate material around the hole to yield or crush.
The overall strength that a single rivet can safely contribute to a joint is limited by whichever of these failure modes requires the least amount of force to occur. Therefore, the rivet value is defined as the minimum strength calculated from the possible shearing failure of the rivet and the possible bearing failure of the rivet or the plate material around the hole.
In simpler terms, the rivet can only withstand a force up to the limit of its weakest failure mode. If the force exceeds the shearing strength, the rivet will shear. If the force exceeds the bearing strength, the material around the hole will crush or the rivet itself will be crushed. To ensure the joint is safe, the design must consider the lower of these two strengths.
Thus, the rivet value is the minimum of the shearing strength and the bearing strength of the rivet.
According to IS-800, for rivets of diameter ‘d’ ,minimum rivet pitch will be -
According to IS-800, gross diameter of rivets of nominal diameter up to 25 mm is-
Calculate the minimum spacing of 20 mm diameter bolt as per IS 800-2007.
Calculate the value of minimum edge distance for 20 mm diameter bolt using machine flame cut.