All Exams Test series for 1 year @ ₹349 only
Question

Calculate the minimum spacing of 20 mm diameter bolt as per IS 800-2007.

The correct answer is

50 mm

Minimum Spacing of Bolts Explained

In structural steel design, the proper spacing of bolts in a connection is crucial for ensuring the strength and safety of the structure. Minimum spacing, also known as minimum pitch, refers to the shortest distance allowed between the centers of two adjacent bolt holes in the direction of force, or between the center of a bolt hole and the edge of a plate.

The primary reasons for specifying minimum spacing are:

  • To prevent the premature tearing or shearing of the plate material between bolt holes due to excessive stress concentration.
  • To avoid bearing failure of the plate material around the bolt hole.
  • To allow sufficient space for proper wrenching and tightening of the bolts during fabrication and erection.

IS 800-2007 Guidelines for Bolt Spacing

The Indian Standard IS 800-2007, which provides the code of practice for general construction in steel, specifies guidelines for the minimum and maximum spacing of bolts in bolted connections. These guidelines are essential for the safe and efficient design of steel structures.

According to Clause 10.2.1 of IS 800-2007, the minimum pitch (center-to-center distance of bolts in a line) should not be less than 2.5 times the nominal diameter of the bolt ($d$). This rule is applied universally for all types of bolts used in structural steel connections.

The formula for minimum pitch is given as:

$$\text{Minimum Spacing} = 2.5 \times d$$

Where:

  • $\text{Minimum Spacing}$ is the minimum required distance between bolt centers.
  • $d$ is the nominal diameter of the bolt in mm.

Calculating Bolt Spacing for a 20 mm Diameter Bolt

Let's apply the IS 800-2007 guideline to calculate the minimum spacing for a 20 mm diameter bolt.

  • Given: Nominal diameter of the bolt ($d$) = 20 mm

Using the formula for minimum spacing as per IS 800-2007:

$$\text{Minimum Spacing} = 2.5 \times d$$

Substitute the given bolt diameter into the formula:

$$\text{Minimum Spacing} = 2.5 \times 20 \text{ mm}$$

$$\text{Minimum Spacing} = 50 \text{ mm}$$

The calculation is summarized in the table below:

Parameter Value
Nominal Bolt Diameter ($d$) 20 mm
Minimum Spacing Formula (IS 800-2007) $2.5 \times d$
Calculated Minimum Spacing $2.5 \times 20 \text{ mm} = 50 \text{ mm}$

Conclusion on Minimum Bolt Spacing

Based on the calculations derived from IS 800-2007, the minimum spacing required for a 20 mm diameter bolt is 50 mm. Adhering to this minimum spacing requirement is vital for ensuring the structural integrity and performance of bolted connections in steel structures.

Was this answer helpful?

Important Questions from Riveted Connections

  1. According to IS-800, for rivets of diameter ‘d’ ,minimum rivet pitch will be -  

  2. Rivet value is defined as -

  3. According to IS-800, gross diameter of rivets of nominal diameter up to 25 mm is-

  4. Calculate the value of minimum edge distance for 20 mm diameter bolt using machine flame cut.

  5. Design of a riveted joint, is based on the assumption
Need Expert Advice?

Start Your Preparation with Prepp Mobile App

Download the app from Google Play & App Store
Download the app from Google Play & App Store
Prepp Mobile App