If you measure the amount of electric charge flowing in a circuit, which SI unit would you use to record the result?
Coulomb
Electric charge flowing in a circuit is measured in Coulomb, the SI unit of electric charge.
Ohm measures resistance, Volt measures potential difference, and Ampere measures current (rate of charge flow) — not the total charge itself.
Hence, Coulomb is the correct answer.
Similar Questions
- Three wires of resistance 3 ohm, 6 ohm and 9 ohm are connected in a parallel. What will be the total resistance of the circuit?
- Which of the following devices is used to convert alternating current into direct current?
According to Joule's law of heating, heat produced in a resistor is expressed by which relation?
Electrical conductors are materials that possess which of the following properties?
When considering the dimensions of electric charge, which fundamental units must be combined to express it in terms of SI base quantities?
What change occurs in the amount of heat produced when the electric current in a conductor is doubled?
- Which one is not a good conductor of electricity?
The quantity represented by the unit volt per ampere corresponds to which electrical unit?
A wire of resistance 10 ohms is cut into two equal pieces. If these pieces are connected in parallel, what is the equivalent resistance?
The flow of electric current in acidic solutions is due to:
Important Questions from Current Electricity
Which of the following is a bad conductor of electricity?
In general, in an alternating current circuit
The laws of electromagnetic induction have been used in the construction of a
A 220 volt and 100 watt bulb is connected to a 110 volt source. The power consumption by the bulb is
In the series combination of resistance in current electricity, which of the following is correct?
