Which tool safety measure best prevents injuries when cleaning a workshop lathe after use?
Using a brush to remove metal chips from the lathe
To determine the best tool safety measure when cleaning a workshop lathe, we need to consider how each option affects safety:
- Blowing chips away with compressed air around the lathe: Although often used for cleaning, this method can scatter metal chips dangerously and potentially cause injury to the eyes and skin. Additionally, it might also result in the chips becoming embedded in machinery parts, possibly causing damage. Therefore, this method is not recommended for safety reasons.
- Wiping metal chips using bare hands directly: This is extremely unsafe. Metal chips can be sharp and small, making it very easy to suffer cuts and injuries when handled with bare hands. Therefore, this is not a safe measure to use while cleaning.
- Using a brush to remove metal chips from the lathe: This option is the safest as it uses a tool designed for cleaning that minimizes direct hand contact with metal chips. Brushes can effectively remove chips without scattering them or causing personal injury, thereby enhancing safety.
- Using a rag to remove metal dust from the lathe: While this might be effective for dust, it is not ideal for removing metal chips as rags can snag on sharp edges, leading to tears or cuts. Hence, using a rag may not be the best method for safety when dealing with metal chips.
Based on the analysis above, the safest method for cleaning a lathe in a workshop setting is using a brush to remove metal chips from the lathe.
Similar Questions
What is the first step when encountering a system failure in a workplace?
Which of the following is a key electrical safety tip in a workshop?
What should be the position of the 'OFF' marking on a fireman's switch?
- Identify the correct pair of Personal Protective Equipment (PPE) categories based on the nature of the hazard.
- Which of the following statement(s) is/are true regarding electrical safety practices? 1. It is safe to plug multi-outlet bars into other multi-outlet bars as long as the total load does not exceed the rated capacity of the outlets. 2. Electrical equipment should not be used near wet surfaces or when your hands are wet, and power cords should be protected by avoiding placement under rugs or mats.
- What is the recommended action before replacing a fuse?
- Which of the following statements are true regarding general safety in the workshop? Statement 1: Use any available tool for the job, even if it is not the correct one. Statement 2: Keep the tools in their proper place after use. Statement 3: Clean the machine while it is still running. Statement 4: Replace worn-out or damaged tools immediately.
- What is the first step in providing first aid for a minor burn?
- What is the most effective way to avoid mechanical hazards when operating large and dangerous machines?
- What is the primary purpose of implementing Lockout/Tagout (LOTO) procedures when working on a DC motor?
Important Questions from Occupational Safety and Health
Which of the following aspects is not a part of safe work place?
Which of the following cannot be used as a safety device?
The only thing that can keep you safe consistently is
Hoists and lifts used for carrying persons shall be fitted with
What is the first step when encountering a system failure in a workplace?
