Which operation is NOT suitable for a single cut file?
Heavy stock removal
A single cut file has one set of parallel teeth cut across its face, which shears off very thin chips and gives a smooth finish.
It is therefore suited to fine finishing, truing flat surfaces and light deburring.
Heavy stock removal needs the deeper, faster-cutting action of a double cut file, whose crossed teeth remove metal quickly.
Hence, heavy stock removal is NOT suitable for a single cut file.
Similar Questions
Which feature should be included in a free hand sketch of a flat file used in the workshop?
What is the main use of a warding file?
Which of the following best describes the primary use of a pillar file in fitting work?
If a file is too short for a given job, what is the most likely result during use?
Which operation cannot be performed efficiently with a half round file?
A file is not removing material efficiently. What is the likely cause?
Which application is most suitable for a triangular file?
Which file is best suited for filing internal corners?
When smoothing a rough metal surface, which file type would provide a faster finish?
A fitter is required to file the inner curvature of a pipe and its flat edge. Which file is most suitable?
Important Questions from File
Which one of the following is a multi-point cutting tool?
What material is used to make file?
What is the name of the hand tool that has small sharp teeth in rows and is used for sharpening or shaping material?
Which is not the part of a file?
The file used for filling leather is
