When smoothing a rough metal surface, which file type would provide a faster finish?
Double cut file
A double cut file has two rows of teeth crossing each other, so it forms many small cutting points.
These extra cutting edges remove metal quickly and cut faster than a single cut file, which has only one set of parallel teeth and is used for finishing.
Hence, the double cut file provides a faster finish on a rough surface.
Similar Questions
Which feature should be included in a free hand sketch of a flat file used in the workshop?
What is the main use of a warding file?
Which of the following best describes the primary use of a pillar file in fitting work?
Which operation cannot be performed efficiently with a half round file?
If a file is too short for a given job, what is the most likely result during use?
A file is not removing material efficiently. What is the likely cause?
Which application is most suitable for a triangular file?
Which file is best suited for filing internal corners?
A fitter is required to file the inner curvature of a pipe and its flat edge. Which file is most suitable?
Which operation is NOT suitable for a single cut file?
Important Questions from File
Which one of the following is a multi-point cutting tool?
What material is used to make file?
What is the name of the hand tool that has small sharp teeth in rows and is used for sharpening or shaping material?
Which is not the part of a file?
The file used for filling leather is
