Which of the following is NOT a purpose of using dividers in fitting operations?
Measuring the thickness of plates
The nature of a tool defines its purposes, and dividers are a marking tool with two straight, sharply pointed legs set to a distance rather than a graduated measuring instrument.
Because the legs can be locked at a set opening, dividers are used to transfer a distance taken from a rule onto the workpiece accurately.
With one point as a centre, the other point scribes circles and arcs on a marked-out surface, which is a routine layout use.
By stepping the set opening along a line, dividers also divide that line into a number of equal parts.
All these uses involve setting and scribing distances, but the legs carry no scale or jaws, so dividers cannot read a value such as the thickness of a plate.
Measuring plate thickness needs a graduated jaw instrument like a vernier caliper or micrometer, so that is the task dividers are not meant to perform.
Hence, the answer is Measuring the thickness of plates.
Similar Questions
A fitter is tasked with marking accurate parallel lines on a metal plate before cutting. He must select a divider with tips made of a suitable material for this job. Which divider tip material would be most appropriate to use to avoid rapid wear and ensure precise marking on the metal surface?
In a workshop, a mechanic needs to determine the length of the diagonal support for a rectangular metal plate with sides of 9 cm and 12 cm. Which value represents the correct length of the diagonal support needed?
Why is centre punching necessary on curved or cylindrical surfaces?
Which operation most benefits from using a V-block with a clamp?
In marking operations, a V-block is mainly used to:
Why are V-blocks often used in pairs when supporting long cylindrical workpieces?
Which tool is most appropriate for marking parts before removing them during diesel engine dismantling to ensure correct reassembly?
If a flat chisel is used instead of a center punch before drilling, what problem might occur?
Which of the following is a correct use of a centre punch during layout work?
A student marks a line with a scriber, but the line is barely visible. What might be the most likely cause?
Important Questions from Marking and Marking Tools
What is the point angle of prick punch which is used for making light punch marks?
The point angle of scriber is
The angle of the punch used for witness marks is
A fitter is tasked with marking accurate parallel lines on a metal plate before cutting. He must select a divider with tips made of a suitable material for this job. Which divider tip material would be most appropriate to use to avoid rapid wear and ensure precise marking on the metal surface?
In a workshop, a mechanic needs to determine the length of the diagonal support for a rectangular metal plate with sides of 9 cm and 12 cm. Which value represents the correct length of the diagonal support needed?
