All Exams Test series for 1 year @ ₹349 only
Question

The observed value of the standard penetration (N) at 10 m depth of silty sand deposit is 13. The unit weight of the soil is 16 kN/m 3. The N value after correcting for the presence of fines will be:

The correct answer is

13

Understanding SPT N Value Correction for Fines

The Standard Penetration Test (SPT) is a common in-situ test used in geotechnical engineering to determine the resistance of soil to penetration and to estimate soil properties. The result of the test is the 'N' value, which is the number of blows required to drive the sampler the final 30 cm of a total penetration of 45 cm.

The observed SPT N value can be affected by various factors, such as overburden pressure, presence of the water table, and the nature of the soil, particularly the presence of fine-grained particles like silt or clay. Therefore, corrections are often applied to the observed N value to get a more representative value for design purposes.

Correcting SPT N Value for Fines

The question specifically asks for the correction due to the presence of fines in the silty sand deposit. A commonly used correction for the presence of fine-grained soil (silt and clay) is the Terzaghi and Peck correction. This correction is typically applied when testing in saturated fine sands or silty sands below the water table (though the question doesn't specify water table depth, the correction rule itself is based on the observed N value and soil type).

The rule for this correction states:

  • If the observed N value ($N_{obs}$) is greater than 15, the corrected N value ($N'$) is calculated using the formula: $$N' = 15 + 0.5 (N_{obs} - 15)$$
  • If the observed N value ($N_{obs}$) is less than or equal to 15, no correction for fines is applied, and the corrected N value is equal to the observed N value: $$N' = N_{obs}$$

Applying the Fines Correction to the Given Data

We are given:

  • Observed SPT N value ($N_{obs}$) = 13
  • Soil type = Silty sand
  • Depth = 10 m
  • Unit weight = 16 kN/m³

We need to apply the correction for the presence of fines based on the observed N value of 13.

According to the rule for fines correction, we check if the observed N value is greater than 15:

Is $N_{obs} > 15$? $13 > 15$? No, this condition is not met.

Since the observed N value (13) is not greater than 15, the rule states that no correction for fines is necessary.

Therefore, the N value after correcting for the presence of fines remains the same as the observed N value.

Corrected N value ($N'$) = $N_{obs}$ = 13.

Other corrections, such as the overburden pressure correction, are not requested in this specific question.

Result of SPT N Value Fines Correction

Based on the standard correction method for fines, the observed SPT N value of 13 does not require adjustment because it is not greater than 15. The corrected N value for the presence of fines is thus 13.

Was this answer helpful?

Important Questions from Shallow Foundation

  1. Which one of the following provides required depth of foundation of a retaining wall?

    Where q: bearing capacity; γ unit weight of the soil; ϕ: angle of repose; B: width of foundation
  2. According to Rankine's formula minimum depth of foundation when q = 180 kN/m 2, γ = 20 kN/m 3and ϕ = 30° is -

  3. The maximum permissible settlement as per IS-1904(1966) for an isolated foundations are :

  4. Temporary structure constructed in a river or lake for excluding water from a given site is termed as ________.

  5. The IS code used to perform a standard penetration test is:

Need Expert Advice?

Start Your Preparation with Prepp Mobile App

Download the app from Google Play & App Store
Download the app from Google Play & App Store
Prepp Mobile App