All Exams Test series for 1 year @ ₹349 only
Question

In tri-axial compression test, the length of specimen is kept about ________ its diameter.

The correct answer is

2 times

Tri-axial Compression Test Specimen Dimensions

The tri-axial compression test is a widely used laboratory method in geotechnical engineering to determine the shear strength parameters (cohesion, $c$, and angle of internal friction, $\phi$) of a soil sample under different confining pressures. Accurate determination of these parameters relies heavily on the proper preparation and dimensions of the soil specimen.

Specimen Preparation in Tri-axial Testing

For a reliable tri-axial compression test, the soil specimen needs to be prepared carefully to ensure its integrity and representativeness. One crucial aspect of specimen preparation is maintaining specific dimensional ratios, particularly the ratio of its length to its diameter. This ratio helps in achieving uniform stress distribution throughout the specimen during the test and minimizing the influence of end effects caused by friction between the specimen and the loading platens.

Length to Diameter Ratio for Tri-axial Specimens

In the tri-axial compression test, the standard practice for preparing cylindrical soil specimens dictates a specific relationship between its length and its diameter. This ratio is critical for obtaining consistent and accurate test results. If the specimen is too short, the friction at the end platens can significantly affect the failure plane and the measured strength. If it's too long, buckling might occur, or uniform strain distribution might be difficult to maintain.

  • The most commonly accepted and specified ratio for the length of the specimen to its diameter in a tri-axial compression test is approximately 2 times.
  • This means if the specimen has a diameter $D$, its length $L$ should be approximately $2D$.
  • For instance, a specimen with a diameter of 38 mm would typically have a length of about 76 mm. Similarly, a 50 mm diameter specimen would have a length of about 100 mm.
  • This standard ratio helps ensure that the central portion of the specimen experiences a relatively uniform state of stress and strain, minimizing the impact of end restraint effects and allowing for a well-defined failure plane to develop.

Adhering to this standard length-to-diameter ratio is essential for the comparability and reliability of tri-axial compression test results across different laboratories and studies.

Was this answer helpful?

Important Questions from Shear Strength

  1. In-situ vane shear test is conducted to determine the shear strength of

  2. For saturated soil, Skempton's pore pressure coefficient B is

  3. The failure plane in direct shear test is:-

  4. When drainage is permitted throughout the triaxial test, it is known as:

  5. The Mohr-Coulomb failure theory represents which of the following equation as the line that represents the failure envelope ?

Need Expert Advice?

Start Your Preparation with Prepp Mobile App

Download the app from Google Play & App Store
Download the app from Google Play & App Store
Prepp Mobile App