The smallest water content at which the soil is saturated, is indicated by:
shrinkage limit
Understanding the water content limits in soil behavior is crucial in soil mechanics. These limits, known as Atterberg limits, define the boundaries between different states of consistency of a fine-grained soil as its water content changes.
The shrinkage limit (SL) is defined as the maximum water content at which a decrease in water content will not cause a decrease in the volume of the soil mass. It is also the lowest water content at which the soil is still completely saturated. Below the shrinkage limit, as water evaporates, air enters the pores, and the volume remains constant.
Let's briefly look at the other limits to understand why shrinkage limit is the correct answer:
These limits represent different water contents:
Solid State <-- SL --> Semi-Solid State <-- PL --> Plastic State <-- LL --> Liquid State
At water contents above the shrinkage limit, the soil is typically saturated. As the soil dries from a very wet state, its volume decreases proportionally to the volume of water lost, maintaining saturation, until the shrinkage limit is reached. At the shrinkage limit, the soil volume stops decreasing, but the soil pores are still filled entirely with water, meaning it is saturated at this specific water content. Any further drying below the shrinkage limit causes air to enter the pores, and the soil is no longer fully saturated, even though its volume remains constant.
Therefore, the shrinkage limit represents the smallest water content at which the soil is saturated before drying causes air intrusion into the pores and stops volume change.
| State | Water Content Range | Volume Change on Drying | Saturation Level |
|---|---|---|---|
| Liquid | w > LL | Decreases | Saturated |
| Plastic | PL < w < LL | Decreases | Saturated |
| Semi-Solid | SL < w < PL | Decreases | Saturated |
| Solid | w < SL | Constant | Partially Saturated |
The table above shows that while the soil is saturated in the Liquid, Plastic, and Semi-Solid states, the transition to the Solid state occurs at the shrinkage limit (SL). Below SL, the soil becomes partially saturated. Thus, SL is the lowest water content point where the soil is still fully saturated.
The question asks for the smallest water content at which the soil is saturated. Based on the definitions of the Atterberg limits and the behavior of soil during drying, this point is the shrinkage limit. At this water content, the soil volume has shrunk to its minimum constant value, and all the pore space is filled with water, resulting in full saturation.
Identify the correct relation between the void ratio (e) and porosity (n) related to soil mechanics.
The ratio of volume of air voids to the volume of the total voids in known as
Valid range for the degree of saturation (S) of soil in percentage is
The minimum water content in a soil at which the soil just begins to crumble when rolled into threads of 3 mm in diameter, is known
A fully saturated soil is said to be