The shear lag effect in beam flanges is disregarded when the width of flange with outstand supported along one edge is less than or equal to (Here L0 is the length between points of zero moment in the span)
Lo / 20
The shear lag effect refers to the phenomenon where the stress distribution across the width of a beam flange is non-uniform, especially near points of load application or abrupt changes in cross-section. This non-uniformity is more pronounced when a portion of the flange, known as the outstand, is supported only along one edge.
In structural engineering design, particularly for steel structures, specific criteria are used to determine when complex effects like shear lag can be simplified or disregarded to streamline calculations. For the shear lag effect in beam flanges, a common rule of thumb is applied based on the width of the flange outstand and its unsupported length.
According to standard structural design principles, the shear lag effect is generally considered negligible, and thus disregarded, when the width of the flange outstand (supported along one edge) is relatively small compared to the effective length between points of zero bending moment ($L_o$).
The question asks for the condition under which this effect is disregarded. Based on established practices and design codes (often found in specifications like the AISC or Eurocode for steel structures, although the exact value can vary slightly), the shear lag effect is typically disregarded when the width of the flange with an outstand supported along one edge is less than or equal to a fraction of $L_o$.
Specifically, the threshold commonly used is:
Where $L_o$ represents the length between points of zero moment in the span, often related to the span length or the distance between lateral bracing points.
Comparing this to the options provided:
The condition that matches the standard rule for disregarding the shear lag effect is $L_o / 20$.
Maximum Slenderness ratio of a compression member carrying loads resulting from wind or seismic load provided the deformation of such members does not adversely effect the stress in any part of member-
Which of the following failure is not a type of failure in tension members in steel structures?
The design bending strength of a laterally unsupported beam is given by?
(1) βb \(\frac{{{z_p}{f_y}}}{{{\gamma _{mo}}}}\)
(2) β b Z p f bd
(3) β b Z p X LT \(\frac{{{f_y}}}{{{\gamma _{mo}}}}\)
(4) β b Z p \(\frac{{{f_{bd}}}}{{{\gamma _{mo}}}}\)
When the length of a tension member is too long:
The allowable stress in axial tension is generally kept less if the thickness of the member is more than