All Exams Test series for 1 year @ ₹349 only
Question

Maximum Slenderness ratio of a compression member carrying loads resulting from wind or seismic load provided the deformation of such members does not adversely effect the stress in any part of member-

The correct answer is

250

Maximum Slenderness Ratio for Compression Members

The slenderness ratio of a structural member is a key parameter in structural design, particularly for compression members. It is defined as the ratio of the effective length of the member to its least radius of gyration.

$\lambda = \frac{KL}{r_{min}}$

Where:

  • $\lambda$ is the slenderness ratio.
  • $K$ is the effective length factor.
  • $L$ is the actual length of the member.
  • $r_{min}$ is the minimum radius of gyration of the member's cross-section.

The slenderness ratio helps predict the buckling behaviour of compression members. Higher slenderness ratios indicate a greater susceptibility to buckling failure.

Building codes, such as IS 800 (the Indian Standard code for steel structures), specify maximum permissible slenderness ratios for different types of members under various loading conditions. These limits are intended to prevent premature buckling and ensure structural stability.

The question specifically asks about the maximum slenderness ratio for a compression member carrying loads resulting from wind or seismic load, with the condition that the deformation of such members does not adversely affect the stress in any other part of the structure.

According to IS 800:2007, Table 3, Cl. 3.7.1, the maximum slenderness ratio for a compression member normally carrying loads resulting from wind or seismic forces only, provided the deformation does not adversely affect the stress in any part of the structure, is limited.

Let's examine the options provided in the context of this specific requirement:

  • Option 1: 250
  • Option 2: 120
  • Option 3: 350
  • Option 4: 180

Based on the provisions of IS 800:2007, the maximum permissible slenderness ratio for the condition described (compression member, wind or seismic load, no adverse deformation effect) is 250.

For comparison, some other common slenderness ratio limits are:

  • Compression members subject to dead and live loads: 180
  • Tension members in which a reversal of direct stress occurs due to loads other than wind or seismic: 180
  • Members normally acting as tension members, but subject to reversal of stress resulting from wind or seismic forces: 350
  • Members always in tension (except pre-tensioned members): 400

Therefore, for a compression member carrying loads resulting from wind or seismic forces, where deformation is not critical to other parts, the maximum slenderness ratio allowed is 250.

Was this answer helpful?

Important Questions from Tension Member

  1. Which of the following failure is not a type of failure in tension members in steel structures?

  2. The design bending strength of a laterally unsupported beam is given by?

    (1) βb \(\frac{{{z_p}{f_y}}}{{{\gamma _{mo}}}}\)

    (2) β b Z p f bd

    (3) β b Z p X LT \(\frac{{{f_y}}}{{{\gamma _{mo}}}}\)

    (4) β b Z p \(\frac{{{f_{bd}}}}{{{\gamma _{mo}}}}\)

  3. When the length of a tension member is too long:

  4. The allowable stress in axial tension is generally kept less if the thickness of the member is more than

  5. The shear lag effect in beam flanges is disregarded when the width of flange with outstand supported along one edge is less than or equal to (Here L0 is the length between points of zero moment in the span)

Need Expert Advice?

Start Your Preparation with Prepp Mobile App

Download the app from Google Play & App Store
Download the app from Google Play & App Store
Prepp Mobile App