A. Mean stress is zero for fluctuating stress
B. Minimum stress is zero for repeated stress
C. Mean stress is zero for reversed stress
D. Amplitude stress is the average of minimum and maximum stress
Choose the most appropriate answer from the options given below :
This solution analyzes the characteristics of different stress states under varying (sinusoidal) loads.
When a component experiences a sinusoidal varying load, the stresses can be described using the following parameters:
Statement: Mean stress is zero for fluctuating stress.
Analysis: Fluctuating stress varies over time but does not necessarily pass through zero or reverse direction. The mean stress ($\sigma_m$) can be positive, negative, or zero depending on the specific range of variation. It is only zero if $\sigma_{max} = -\sigma_{min}$. Therefore, this statement is incorrect as a general rule for fluctuating stress.
Statement: Minimum stress is zero for repeated stress.
Analysis: Repeated stress typically implies the stress varies from a minimum value up to a maximum value. A common definition assumes the stress varies from zero ($\sigma_{min} = 0$) up to a maximum value ($\sigma_{max}$). Under this definition, the minimum stress is zero. Therefore, this statement is generally considered correct.
Statement: Mean stress is zero for reversed stress.
Analysis: Reversed stress signifies a complete reversal of stress, varying from a maximum tensile stress ($\sigma_{max}$) to an equal magnitude compressive stress ($\sigma_{min} = -\sigma_{max}$). Calculating the mean stress: $\sigma_m = \frac{\sigma_{max} + (-\sigma_{max})}{2} = \frac{0}{2} = 0$. Thus, the mean stress is zero. This statement is correct.
Statement: Amplitude stress is the average of minimum and maximum stress.
Analysis: The amplitude stress is defined as half the range of stress ($\sigma_a = (\sigma_{max} - \sigma_{min})/2$). The average of the minimum and maximum stress is the mean stress ($\sigma_m = (\sigma_{max} + \sigma_{min})/2$). These are different quantities unless $\sigma_{min} = -\sigma_{max}$ (reversed stress), where $\sigma_a = |\sigma_{max}|$ and $\sigma_m = 0$. Therefore, this statement is incorrect as a general definition.
Based on the analysis, statements B and C are correct descriptions related to specific types of varying stress.
Correct statements: B and C only.
| List-I | List-II |
| Electronic Configuration | First Ionisation energy (kJ mol$^{-1}$) |
| (A). ns$^2$ | (I). 2100 |
| (B). ns$^2$np$^1$ | (II). 1400 |
| (C). ns$^2$np$^3$ | (III). 800 |
| (D). ns$^2$np$^6$ | (IV). 900 |
| List-I | List-II |
| Spectroscopy | Property |
| (A). Raman | (I). Polarizability |
| (B). FTIR | (II). Dipole Moment |
| (C). UV-Visible | (III). Absorbance |
| (D). NMR | (IV). Spin |