The Los Angels abrasion value requirement for coarse aggregates used in water bound macadam for the base course is:
Between 40 to 50%
The Los Angeles abrasion test is a standard method used to measure the resistance of coarse aggregates to abrasion, impact, and grinding. This test is crucial for evaluating the quality and durability of aggregates intended for use in road construction. Aggregates are subjected to wear and tear from traffic loads and environmental factors, so their ability to resist disintegration is paramount for the longevity of a pavement structure.
For Water Bound Macadam (WBM) construction, aggregates form the structural layer. WBM is traditionally used for base or sub-base courses in pavement structures. The quality requirements for aggregates vary depending on the specific layer they are used in.
The question specifically asks about the Los Angeles abrasion value requirement for coarse aggregates used in the base course of Water Bound Macadam. According to standard specifications for highway construction, the maximum permissible Los Angeles abrasion value for coarse aggregates used in WBM base course is specified to ensure adequate durability and performance under traffic loading.
The specified limit for the Los Angeles abrasion value for aggregates used in the base course of WBM is typically 50%.
Let's look at the given options:
The option "Between 40 to 50%" aligns with the standard requirement where the maximum limit is 50%. This range indicates that aggregates with an abrasion value up to 50% are acceptable for use in WBM base course.
A lower Los Angeles abrasion value indicates higher resistance to wear and tear. Aggregates with high abrasion values tend to break down more easily under traffic, leading to:
Therefore, specifying a maximum limit for the Los Angeles abrasion value is essential to ensure that the aggregates used are sufficiently strong and durable for the intended purpose, especially in a load-bearing layer like the base course.
Sometimes, slightly different requirements might exist for different WBM layers (e.g., sub-base vs. base) or for surface course aggregates (like those used in bituminous mixes), which are often stricter. However, for WBM base course, the 50% limit is widely adopted.
Based on standard specifications for road construction using Water Bound Macadam, the Los Angeles abrasion value requirement for coarse aggregates used in the base course is a maximum of 50%. The option that best represents this requirement is "Between 40 to 50%".
| Test | Property Measured | Importance |
|---|---|---|
| Los Angeles Abrasion Test | Resistance to abrasion, impact, grinding | Indicates aggregate durability and strength against mechanical wear |
| Aggregate Crushing Value Test | Resistance to crushing under compressive load | Measures strength of aggregate under static load |
| Aggregate Impact Value Test | Resistance to sudden shock or impact | Measures toughness of aggregate |
| Specific Gravity & Water Absorption | Density and porosity | Affects aggregate weight, strength, and performance in presence of moisture |
Water Bound Macadam is a type of road construction where crushed aggregates are mechanically interlocked by rolling and bound together with screenings and water. The layers are compacted until a rigid, dense mass is formed. WBM layers rely heavily on the interlocking and quality of the aggregates for their structural capacity. Proper aggregate grading and adherence to tests like the Los Angeles abrasion test are critical for constructing a durable WBM layer.
The Optimum Bitumen Content (OBS) in Bituminous Mix is determined by:
Bitumen penetration test is widely used for:
The softening point of various bituminous grades in (degree centigrade) for paving jobs vary between
The Marshall Stability value for bituminous mixes for heavy traffic shall be not less than
The ductility of bitumen is expressed as