All Exams Test series for 1 year @ ₹349 only
Question

According to Federal plumbing rules, the gallon to use in new toilets is

The correct answer is 1.6

Understanding Federal Plumbing Rules for Toilets

Federal plumbing rules in the United States set standards for the maximum amount of water new toilets can use per flush. This is primarily aimed at promoting water conservation across the country. These standards have evolved over time to encourage more efficient use of water resources.

Federal Standard for New Toilet Gallons Per Flush (gpf)

A significant piece of legislation that impacted toilet water usage was the Energy Policy Act of 1992. This act mandated that new toilets manufactured and sold in the U.S. could use no more than a specific amount of water per flush. This standard became widely known and implemented in plumbing codes nationwide.

According to these federal plumbing rules, the maximum flow rate for new toilets is 1.6 gallons per flush (gpf). Toilets meeting this standard are often referred to as "low-flow" toilets.

Before this federal rule, toilets typically used much more water per flush, often in the range of 3.5 gallons or even more.

Comparing Options to the Federal Standard

Let's look at the options provided in the question:

  • 5.9 gallons: This is significantly higher than current standards and is not the allowed amount for new toilets under federal rules.
  • 3.5 gallons: This was a common standard for older toilets manufactured before the Energy Policy Act of 1992, but it is not permitted for new installations under federal rules.
  • 1.6 gallons: This value matches the maximum gallons per flush (gpf) established by the federal standard for new toilets.
  • 4.3 gallons: This value does not correspond to either the current federal standard or a common previous standard for toilets.

Therefore, according to the federal plumbing rules, the gallon amount to use in new toilets is 1.6 gallons per flush.

Was this answer helpful?

Important Questions from Distribution of Water

  1. The cast iron pipes:

  2. If Q is the total quantity of water required by a town per year in litres, and P is the population of the town, then the per capita demand of water will be:

  3. Which of the following is NOT a type of variation in demand?
  4. Which of the following IS -Code is used for the basic requirements for water supply, drainage and sanitation?

  5. The layout of distribution of which water flows towards the outer periphery is

Need Expert Advice?

Start Your Preparation with Prepp Mobile App

Download the app from Google Play & App Store
Download the app from Google Play & App Store
Prepp Mobile App